Warmachine, Warhammer 40k, & Terrain Projects

Posts tagged “power fist

Building the Reaver Titan PowerFist

Goal: A fully magnetized and positionable reaver titan powerfist.

  1. Understand where each piece fits. While it’s obvious now, before I started assembling the arm I thought that the ‘wrist end’ of the arm was actually the ‘shoulder end.’ This ended up being okay, as I realized it before magnetizing the hand itself, but could have been disastrous had that not been the case. Take a second to carefully read the instructions, ID the parts, and figure our which parts go where. Test fit. In particular, separate the thumb finger set of pieces, the two ‘long’ sets of finger pieces, and the two ‘short’ sets of finger pieces. The thumb pieces only very slightly, with some wider knuckle covers, joins, etc.
  2. Optionally, magnetize the arm. I magnetized the mount to the shoulder, the first joint below the shoulder, and the wrist. I didn’t magnetize the elbow as there wasn’t an obvious way to do that joint, and it’s already a bit ‘fiddly’ with the three other magnetized joints (although with the 1/2 x 1/4 neodymium magnets is suprisingly secure).One thing to watch out for…I got the first joint ‘backwards’ such that the ‘more armor side’ of the should joint (fart right piece in below picture) was ‘outside.’ (‘up’ in the below picture). In fact, it should be INSIDE (down) if you want to be able to pose the arm ‘up and out’ (as in lift your right elbow away from your body) For the reaver to do that, the ‘short armor side’ of the upper/shoulder joint needs to be facing ‘up/out.’ As a result, my upper arm is ‘backwards,’ the ‘tube’ is facing forward from the inner elbow instead of facing back, and I was unable to use a piston. With all that said, I still think it looks great! If I could do it over again, I’d build it as designed. Ooops! If you build a power fist arm don’t make the same mistake as me!
    Reaver titan magnetized power fist

    (more…)